Stand at the end of the table. Lay out the Pro-Pocket on black ball end of the table and unclip the two connecting plastic clips. Place the left side cushion marked “L” on the inside cushion of the left pocket, with the “L” near to the cushion.
Feed through the plastic clip fastener and the elastic between the pocket netting and the cushion rail, keeping the Pro-Pocket in place.
Unravel any creases in the green ribbon and stretch it straight underneath the cushion. Again, keeping the Pro-Pocket in place on the left side.
Fit the right side of the Pro-Pocket marked “R” to the right pocket on the inside near jaw and again feed the plastic fastener between the netting and cushion rail. You will notice that the right side is adjustable and can slide along the green ribbon and can easily be manipulated into the correct position.
Keeping both sides of the Pro-Pocket in place, clip together the plastic fasteners and your Pro-Pocket is ready to go
A tight fit is important
The propocket inserts are not made from the same cushion rubber that you find on the cushions of a snooker table. Therefore, please be careful not to overpower the shot, causing the balls to bounce awkwardly upon impact and possibly leaving the table. You may find that by reducing the pace of the shot, can increase your pot success alone.
©Copyright UK Design No 6366027
We need your consent to load the translations
We use a third-party service to translate the website content that may collect data about your activity. Please review the details in the privacy policy and accept the service to view the translations.